Rokoko Studio plus or above subscription
Siemens Jack v9.1 Mocap IPC module
Rokoko Studio Settings
Open Rokoko Studio Live
Go to settings and click on Studio Live in the dropdown menu.
Configure the data stream
Before you can begin streaming data you need to configure the receiver information. Start by clicking the cogwheel in the top right corner, which will flip the box around.
Adding a receiver
Add one receiver by clicking the plus button, which applies one receiver to the list. At this stage you can modify the IP address and Port number.
Enabling and disabling a receiver
Each individual receiver can be enabled and disabled by toggling the switch
Enabling the data stream
In order to enable a data stream, at least one receiver has to be enabled
Enable the data stream by clicking on the box. The green outline indicates that the data stream is enabled, click again to disable. Navigate to the settings (top left corner button on the tile) to enter the IP address of the computer you are streaming the data to, as well as the ports.
Simens Jack settings
Open the Mocap IPC module
In the Jack Mocap IPC window, set the port number to the one studio is forwarding to and click "Open".
You should now see the forwarded characters being animated in the TJ_Window of SIemens Jack.